TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 715 of 968

TM 9-2815-210-34-2-2

(2) Engines LDS-465-1 and LDS-465-1A.

FRAME 1

NOTE

Three types of clutch disks (1) are used. Replace-

ment procedures are the same for all types.

1.

Put clutch disk (1) in place against face of flywheel (2) with long end of

clutch drive hub (3) facing out.

NOTE

Clutch alining tool (4) must be left in place until frame

2 is done.

2.

Put clutch alining tool (4) through clutch drive hub (3) and into hole in

center of flywheel (2).

GO TO FRAME 2

5-86