TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 719 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

2.

3.

4.

5.

This task is

assemblies.

assembly.

NOTE

the same for the front and rear rocker arm

This task is shown for the front rocker arm

Loosen six adjusting screw locknuts (1) on front rocker arm assembly (2).

Turn six adjusting screws (3) as far to the left as they will go.

Put front rocker arm assembly (2) on front cylinder head (4). Six mounting

holes (5) in rocker arm assembly must line up with six holes (6) in cylinder

head.

Put in and hand tighten two screws and lockwashers (7), Put in and hand

tighten two screws and lockwashers (8). Put in and hand tighten two

screws and lockwashers (9).

Using torque wrench, tighten two screws (7) to 44 pound-feet. Using torque

wrench, tighten two screws (8) to 44 pound-feet. Using torque wrench,

tighten two screws (9) to 44 pound-feet.

Do steps 1 through 4 again on rear cylinder head (10).

GO TO FRAME 4

5-90