TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 718 of 968

TM 9-2815-210-34-2-2

FRAME 2

NOTE

If you are using push rods (1) that were taken out,

make sure they go in push rod passage (2) they were

taken from.

1.

Lower one push rod (1) through each of 12 push rod passages (2) in cylinder

heads (3). Bottom end of push rod must fit through tappet bore (4) and

rest on tappet (5) inside crankcase (6) as shown.

GO TO FRAME 3

5-89