TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 713 of 968

TM 9-2815-210-34-2-2

b .

Clutch.

(1) Engines LD-465-1, LD-465-1C, and LDT-465-1C.

FRAME 1

WARNING

1.

2.

Clutch disk (1) is heavy. Be careful not to drop it

or it can cause injury to personnel and damage to

equipment.

Put clutch disk (1) in place against face of flywheel (2) with long end of

clutch drive hub (3) facing out.

NOTE

Clutch alining tool (4) must be left in

frame 2 is done.

Put clutch alining tool (4) through clutch drive

center of flywheel (2).

GO TO FRAME 2

place until

hub (3) and into hole in

5-84