TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 714 of 968

TM 9-2815-210-34-2-2

WARNING

Soldiers

A and B

Soldier A

Soldier B

1.

2.

3.

4.

5.

6.

END OF TASK

Pressure plate assembly (1) is heavy. It must be held

firmly up and against flywheel (2) until mounting screws

(4) are put in. If it is not held up, it will fall and cause

injury to personnel and damage to equipment.

Put pressure plate assembly (1) in place against flywheel (2)

Aline eight holes in pressure plate assembly with holes in clutch

disk (3).

Hold pressure plate assembly (1) firmly up and against clutch

disk (3) until eight mounting screws (4) are put in.

Put in eight screws with lockwashers (4).

Tighten eight screws (4) to 23 to 27 pound-feet.

Press four release levers (5), one at a time, using prybar, and

take out release lever spacer blocks (6).

Take out clutch alining tool (7).

5-85