TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 723 of 968

TM 9-2815-210-34-2-2

FRAME 7

1.

2.

3.

4.

5.

NOTE

Cylinders are called number one through six counting

from front to rear of engine. Each cylinder has one

intake valve and one exhaust valve.

Intake valve for

each cylinder is toward front of cylinder and exhaust

valve is toward rear of cylinder.

Slide 0.025-inch feeler gage between cylinder number five exhaust rocker

arm pad (1) and exhaust valve stem (2).

Turn adjusting screw (3) until feeler gage fits snugly between exhaust

rocker arm pad (1) and exhaust valve stem (2).

Keep adjusting screw (3) from turning and tighten locknut (4).

Check that 0.025-inch feeler gage blade still fits snugly between exhaust

rocker arm pad (1) and exhaust valve stem (2). If feeler gage does not

fit snugly, loosen locknut (4) and do steps 1 through 4 again.

Do steps 1 through 4 again for cylinder number three and cylinder number

six exhaust valves.

END OF TASK

5-94