TB-9-2320-280-35-15

TECHNICAL BULLETIN

INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11

SEPTEMBER 2006

TB-9-2320-280-35-15 - Page 101 of 168

5-77

TB 9-2320-280-35-15

NOTE

DAGR power cable positive lead insulation is ribbed.

33-24.

Attach shrink tubing (46) and terminal lugs (44) and (50) to PLGR power cable negative lead (49)

and DAGR power cable positive lead (47). (Refer to TM 9-2320-280-20 for terminal connector

repair.)

33-25.

Attach DAGR power cable positive lead (47) to 24V terminal board (52) located on cab enclosure

panel (43) with existing nut (45).

33-26.

Attach DAGR power cable negative lead (49) to ground strap (51) located on cab enclosure panel (43)

with existing nut (45).

33-27.

Coil excess positive and negative power leads, place beneath ground strap, and secure with tiedown

strap (48).

NOTE

Ensure all excess antenna cable is inside cab of vehicle.

33-28.

Coil excess antenna cable and store under integrated rack using tiedown strap as necessary.

(Refer to figure 5-90.)

33-29.

Install right-side tunnel insulation. (Refer to TM 9-2320-280-20.)

Figure 5-91.

44. TERMINAL LUG – 7728780 – QTY. 1

46. SHRINK TUBING – MS23053/4-302-0 – QTY. A/R

48. TIEDOWN STRAP – MS3367-1-0 – QTY. A/R

50. TERMINAL LUG – 7728777 – QTY. 1

43

44

45

48

45

49

46

50

51

52

46

47

~