TB-9-2320-280-35-15

TECHNICAL BULLETIN

INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11

SEPTEMBER 2006

TB-9-2320-280-35-15 - Page 100 of 168

5-76

TB 9-2320-280-35-15

33-19.

Locate, mark, and drill one 0.147-in. hole (42) in top of windshield frame (2).

33-20.

Route DAGR antenna cable (6) on top of windshield frame (2) and secure with loop clamp (34) and

self-tapping screw (33).

33-21.

Route DAGR antenna cable (6) down through center access hole (37) of integrated rack (38), and

coil excess antenna cable (6) under integrated rack (38).

33-22.

Route DAGR power cable (40) from bracket (39) to right-side tunnel insulation (41).

NOTE

Loosen right-side tunnel insulation before performing step 33-23.

(Refer to TM 9-2320-280-20.)

33-23.

Route DAGR power cable (40) under edge of right-side tunnel insulation (41) to 24V terminal bar at

cab enclosure panel.

Figure 5-90.

33. SELF-TAPPING SCREW – 9421073 – QTY. 1

34. LOOP CLAMP – MS21333-65 – QTY. 1

38. DAGR POWER CABLE – 9728558-10 – QTY. 1

33

42

34

6

2

38

39

40

41

37

~

~