TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 96 of 168
5-72
TB 9-2320-280-35-15
Section XXXIII. ANTENNA AND CABLE INSTALLATION (WITHOUT BOLT-ON ARMOR)
NOTE
• DAGR shown, PLGR similar.
• Drilled holes on inside and outside of windshield frame should be
aligned with each other to allow routing of DAGR cable through
windshield frame.
• Relocate all caution labels as necessary.
• Drilled holes on inside and outside of windshield frame should be
aligned with each other to allow routing of DAGR cable through
windshield frame.
• Use left side plug as reference point to measure hole for antenna
cable.
33-1.
Locate, mark, and drill 0.375-in. diameter hole (1) in outer right-side windshield
frame (2).
33-2.
Locate, mark, and drill 0.375-in. diameter hole (3) in inner right-side windshield frame (4).
Figure 5-85.
2
1
~
Figure 5-86.
~
3
4
1.25
5.12
0.75
3.00
Back to Top
