TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 98 of 168
5-74
TB 9-2320-280-35-15
33-11.
Split one side of grommet (28) and place on DAGR antenna cable (6).
33-12.
Insert DAGR antenna cable (6) and grommet (28) in hole (3) of inner-right windshield frame (2).
NOTE
If sun visor kit has not been installed, perform steps 33-13 and
33-14. If sun visor has been installed, perform step 33-15.
33-13.
Locate, mark, and drill 0.390-in. diameter hole (29) in windshield frame (2).
33-14.
Install insert (30) in hole (29) of inner-right windshield frame (2).
NOTE
Perform step 33-15 only if sun visor kit has been installed.
33-15.
Remove capscrew (25) and lockwasher (26).
33-16.
Route DAGR antenna cable (6) along inner-right windshield frame (2) and secure with loop
clamp (27), lockwasher (26), and capscrew (25).
Figure 5-88.
25
26
27
6
28
2
3
29
30
~
C
L
2.38
25. CAPSCREW – B1821BH025C100N – QTY. 1
26. LOCKWASHER – 120380 – QTY. 1
27. LOOP CLAMP – MS21333-96 – QTY. 1
28. GROMMET – MS35489-143 – QTY. 1
30. INSERT – 12446871-2 – QTY. 1
Back to Top
