TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 74 of 168
TB 9-2320-280-35-15
5-50
Figure 5-59.
6
NOTE
• Remove right rear side rail, if necessary.
(Refer to TM 9-2320-280-20.)
• Front edge of upper antenna plate should be approximately
9.75 in. from edge of front bolts in wheelhouse.
25-3.
Locate screw (11) on right rear wheelhouse (8) and drill out rivet (10) from right rear
wheelwell (8). Enlarge hole to 0.281 in.
25-4.
Position support plate (12) underneath wheelhouse (8) and drill two 0.281-in. diameter holes (13).
25-5.
Using upper antenna plate (6) as template, locate, mark, and drill thirteen 0.281-in. holes (7) and
three 0.408-in. holes (9) in left rear wheelhouse (8).
6. ANTENNA PLATE – A3104004-2 – QTY. 1
9
8
11
10
12
13
~
~
9.75
7
7
7
7
7
Back to Top
