TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 81 of 168
TB 9-2320-280-35-15
5-57
NOTE
Perform step 26-10 only if not installing cargo soft-top enclosure;
otherwise, start with step 26-11.
26-10.
Install antenna (27) on antenna mount assembly (16) with NTDR bracket (29), four capscrews (26),
two gaskets (28), eight lockwashers (34), and four nuts (33).
NOTE
Perform steps 26-11 through 26-13 only when installing cargo
soft-top enclosure.
26-11.
Install cargo soft-top enclosure (35). (Refer to TM 9-2320-280-10.)
NOTE
Ensure all slack has been taken out of cargo soft-top enclosure, and
that cargo soft-top enclosure has been properly installed.
26-12.
Using antenna (27) as template, locate, mark, and drill four 0.375-in. holes (36) and cut “X” (37) in
cargo soft-top enclosure (35).
26-13.
Install antenna (27) on antenna mount assembly (16) and cargo soft-top enclosure (35) with NTDR
bracket (29), four capscrews (26), gaskets (28), eight lockwashers (34), and four nuts (33), ensuring
that ground strap (32) is inserted through cut hole (37).
26-14.
Install ground strap (32) on antenna mount assembly (16) with screw (31), three lockwashers (30),
and nut (21).
26-15.
Tighten nuts (21) and (33).
26-16.
Install NTDR antenna (38) on NTDR bracket (29) with adapter (39), grommet (40), washer (41), and
nut (42).
32
33
34
21
26
16
28
28
29
30
31
Figure 5-66.
30
21. NUT – 9419143 – QTY. 1
26. CAPSCREW – B1821BH038C150N – QTY. 4
27. ANTENNA – A3005031 – QTY. 1
28. GASKET – A3013655-1 – QTY. 1
30. LOCKWASHER – MS45904-68 – QTY. 3
31. CAPSCREW – B1821BH025C075N – QTY. 1
32. GROUND STRAP – QTY. 1
33. NUT – 13218E0320-293 – QTY. 4
34. LOCKWASHER – MS45904-76 – QTY. 8
40
38
34
27
41
29
42
39
~
32
37
26
34
27
28
28
35
34
33
29
36
Back to Top
