TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 76 of 168
TB 9-2320-280-35-15
5-52
NOTE
Perform step 25-10 only if not installing cargo soft-top enclosure;
otherwise, start with step 25-11.
25-10.
Install antenna (27) on antenna mount assembly (25) with four capscrews (26), gasket (28), eight
lockwashers (33), and four nuts (32).
NOTE
Perform steps 25-11 and 25-12 only when installing cargo
soft-top enclosure.
25-11.
Install cargo soft-top enclosure (34). (Refer to TM 9-2320-280-10.)
NOTE
Ensure all slack has been taken out of cargo soft-top enclosure,
and that cargo soft-top enclosure has been properly installed.
25-12.
Using antenna (27) as template, locate, mark, and drill four 0.375-in. holes (35) and cut “X” (36) in
cargo soft-top enclosure (34).
25-13.
Install antenna (27) on antenna mount assembly (25) and cargo soft-top enclosure (34) with four
capscrews (26), gasket (28), eight lockwashers (33), and four nuts (32), ensuring that ground
strap (31) is inserted through cut hole (36).
25-14.
Install ground strap (31) on antenna mount assembly (25) with screw (30), three lockwashers (29),
and nut (20).
25-15.
Tighten all nuts (20) and (32).
Figure 5-61.
20. NUT – 9419143 – QTY. 1
26. CAPSCREW – B1821BH038C150N – QTY. 4
27. ANTENNA – A3005031 – QTY. 1
28. GASKET – A3013655-1 – QTY. 1
29. LOCKWASHER – MS45904-68 – QTY. 3
30. CAPSCREW – B1821BH025C075N – QTY. 1
31. GROUND STRAP – QTY. 1
32. NUT – 13218E0320-293 – QTY. 4
33. LOCKWASHER – MS45904-76 – QTY. 8
26
33
28
27
31
33
32
34
~
31
20
29
32
33
26
27
28
25
30
29
33
35
35
36
Back to Top
