TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 79 of 168
TB 9-2320-280-35-15
5-55
Figure 5-64.
6
13
10
9.75
EPLRS MOUNTING PLATE
9
~
~
~
NOTE
• Remove left rear side rail, if necessary.
(Refer to TM 9-2320-280-20.)
• Front edge of upper antenna plate should be approximately
9.75 in. from edge of front bolts in wheelhouse.
26-3.
Locate screw (9) on left rear wheelhouse (13), and drill out rivet (10) from left rear wheelhouse (13).
Enlarge hole to 0.281 in.
26-4.
Position support plate (8) underneath wheelhouse (13) and drill two 0.281-in. diameter holes (11).
26-5.
Using upper antenna plate (6) as template, locate, mark, and drill thirteen 0.281-in. holes (7) and
three 0.408-in. holes (12) in left rear wheelhouse (13).
6. ANTENNA PLATE – A3104004-1 – QTY. 1
8
7
7
7
7
11
12
Back to Top
