TB-9-2350-277-40-P-2
CARRIER, PERSONNEL, FULL TRACKED, ARMORED M113A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 2 OF 4
JUNE 2009
TB-9-2350-277-40-P-2 - Page 44 of 100
TB 9-2350-277-40&P-2
INSTALLATION PROCEDURES – Continued
0006 00
0006 00-6
6.
Install gasket (15) on GPS mounting bracket (14).
NOTE
If SINCGARS antenna was previously mounted, do Step 7.
If carrier
had no antenna, go to Step 8.
7.
Install SINCGARS antenna on vehicle.
a.
Reroute antenna cable (7) inside vehicle and through antenna opening, GPS mounting
bracket (14), and new gasket (15).
Connect antenna cable (7) to antenna base (3).
NOTE
SINCGARS antenna requires four screws (P/N B1821BH038C175N).
b.
Install SINCGARS antenna (3) over gasket (15), GPS mounting bracket (14), and antenna
opening.
Secure with four screws (18) and retained lockwashers (1).
TORQUE SCREWS
TO 44 LB-FT (59.6 N
·
m).
c.
Connect ground strap (8) to vehicle hull and secure with retained bolt (6) and two
lockwashers (5).
Figure 5.
SINCGARS Antenna Installation
Back to Top
