TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009

TB-9-3950-253-13-P - Page 500 of 704

TB 9-3950-253-13&P

Change 1

0051-14

0051

HEMTT REMOVAL – CONTINUED

Reposition Hydraulic Control Box – Continued

00051

WARNING

•

Appropriate safety precautions (including, but not limited to, wearing proper breathing

apparatus, hearing protection, safety goggles, etc.) must be observed when working with

CARC material.

•

All cutting and grinding must be done using an abrasive device only. Use of a cutting torch,

plasma cutter, etc., is not permitted.

•

Always wear gloves and a face shield or breathing apparatus when grinding painted

surfaces. Airborne particles may cause lung irritation or damage to eyes.

•

Failure to follow these warnings may cause injury or death to personnel.

NOTE

Perform hydraulic cover modification for HEMTT A4 only.

32. At bottom edge of hydraulic cover (Figure 12, Item 2) measure and mark 8.375 in. from inboard edge

(Figure 12, Item 1) of hydraulic cover.

33. At marked point, measure and cut a notch (Figure 12, Item 3) that is .5 in. wide and 1.5 in. long as shown in

Figure 12.

Figure 12.

HEMTT A4 Hydraulic Cover Modification.

051