TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 503 of 704
0051-17
Change 1
TB 9-3950-253-13&P
0051
PLS REMOVAL – CONTINUED
Rear Roller Assembly Removal
00051
WARNING
•
Lifting cables, chains, hooks, and slings used for lifting must be in good condition and of
suitable capacity.
•
Improper use of lifting equipment and improper attachment of cables may cause injury to
personnel and damage to equipment. Observe all standard rules of safety.
•
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device.
•
Failure to follow these warnings may result in injury or death to personnel.
NOTE
•
Rear roller assembly weighs 375 lb (170 kg).
•
Bolts securing light bar will be removed with roller assembly.
1. Attach sling and lifting device to rear roller assembly (Figure 16, Item 1).
2. Use lifting device to remove slack from sling.
3. Remove two bolts (Figure 16, Item 2) and reflector (Figure 16, Item 3) from roller assembly (Figure 16, Item 1).
4. Remove six nuts (Figure 16, Item 7), washers (Figure 16, Item 6), bolts (Figure 16, Item 4), and washers
(Figure 16, Item 5) from roller assembly (Figure 16, Item 1).
5. Use lifting device to remove roller assembly (Figure 16, Item 1) from vehicle.
Figure 16.
Roller Assembly Removal.
051
1
4,5
6,7
2
3
Back to Top
