TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 65 of 704
0007-19
Change 1
TB 9-3950-253-13&P
0007
PICK UP LIFT FRAME FROM GROUND
0007
1. Verify these conditions exist:
a. Lift mechanism in home position (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
b. Vehicle in neutral gear and parking brake applied (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-
14&P).
c.
MODE switch set to OFF (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
d. Stowage toggle switch set to OFF position (WP 0004).
e. Slider beds in container configuration (WP 0006).
f.
Container locking pins on lift frame in stowed position (
Release Locking Pins
in this work package).
g. NO TRANS light off (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
h. HEMTT only: PTO switch in ON position (TM 9-2320-326-14&P).
WARNING
•
Use a ground guide at all times when unloading/loading lift frame.
•
Use extreme caution if high wind conditions exist while unloading/loading lift frame. With
assistance, attach guide straps to the legs of the lift frame to stabilize the lift frame during
the unloading/loading procedure.
•
DO NOT stand directly behind lift frame during unloading/loading.
•
Failure to follow these warnings may result in injury or death to personnel.
2. Position rear of vehicle (Figure 26, Item 1) so it is in front of (i.e., with hook-bar projecting toward vehicle) and
parallel with lift frame (Figure 26, Item 2), and is approximately 5 ft (1.5 m) from lift frame.
Figure 26.
Rear of Vehicle from Lift Frame.
07
467-085
1
2
Back to Top
