TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 150 of 801

TM 9-2320-273-34

(2)

Remove the slipring assembly from the rotor shaft, using a suitable puller (fig. 5-28).

TA 074026

Figure 5-28. Slipring Removal.

(3)

Clean the rotor shaft and apply a small amount of Loctite (Item 19, App B) (or equivalent)

to the shaft on the section normally occupied by the slipring assembly.

(4)

position the new slipring assembly on the shaft so that the two electrical leads are alined

with the two rotor coil eyelets. Carefully press the slipring assembly onto the shaft until it is 3/8 in. from

the rotor (fig.5-29).

TA 074027

Figure 5-29. Slipring Installation.

5-6. Assembly. (See figure 5-30.)

a. Assemble the Alternator.

Assemble the alternator as follows:

(1)

If the slipring end bearing was removed, press a new bearing into the housing from the

outside of the housing. The bearing must be installed with the seal facing in toward the sliprings and the

manufacturer’s part number facing toward the outside of the housing. The bearing should seat against the

lip on the inside end of the bearing bore. After installation, apply a small amount of grease to the rollers.

5-22