TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 174 of 801

TM9-2320-273-34

(3) Remove nut (5, fig. 6-2) and washer (4).

b.

pushed

Figure 6-2.

(4) Using a suitable puller

Installation.

Remove /install Accessory Drive Pulley.

remove pulley (1) and seal (3) from shaft (2). Discard seal (3).

(1) Mount pulley (1) and seal (3) on shaft (2) with flat side of seal facing you and inner side

into keyway (6).

(2) Place short 2X4 board, or other suitable device, acrosss pulley and tap with a mallet until

the pulley is fully seated.

(3) Install washer (4) and nut (5). Tighten to 95 Ib-ft (129 N-m) torque. Seal (3) will crush

against shaft.

(4) Install idler belt. (Refer to TM 9-2320-273-20.)

6-4