TM-9-2320-328-13-P-1
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3
MARCH 2009
TM-9-2320-328-13-P-1 - Page 910 of 1318
TM 9-2320-328-13&P-1
0081-4
DRAFT
0081
Change 1
..
HWT3105
..
..
..
..
..
..
..
..
..
..
CAUTION
Both connector ends of water level probe adapter must be covered with heat
shrink tubing.
Failure to comply will allow moisture to enter connector ends and
not allow water level gauge to function properly.
..
Step 8.
Pull battery disconnect switch to off position (WP 0007).
Reconnect pump operator’s
panel wire harness level gauge connectors to original positions.
Remove foam/water
tank level probe cover (WP 0189).
Disconnect passenger side body wire harness
water level probe connector from foam level probe adapter.
Disconnect passenger
side body wire harness water level probe connector from water level probe adapter.
Connect passenger side body wire harness water level problem connector to foam
level probe adapter.
Push battery disconnect switch to on position (WP 0007).
Check
if pump operator’s panel WATER level gauge E and F LEDs flash alternately.
..
If pump operator’s panel WATER level gauge E and F LEDs flash
alternately, go to Step 10.
..
Step 9.
Pull battery disconnect switch to off position (WP 0007).
Reconnect passenger side
body wire harness level probe connector to original positions.
Disconnect water level
probe adapter from water tank level probe (WP 0175).
Disconnect foam level probe
adapter from foam tank level probe.
Connect water level probe adapter to foam tank
level probe (WP 0175).
Push battery disconnect switch to on position (WP 0007).
Check if pump operator’s panel WATER level gauge E and F LEDs flash alternately.
..
a.
If pump operator’s panel WATER level gauge E and F LEDs flash
alternately, replace water level probe adapter (WP 0175).
..
b.
If pump operator’s panel WATER level gauge E and F LEDs do not
flash alternately, replace water tank level probe (WP 0175).
..
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
