TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 240 of 1616

TM 9-2320-440-13&P

0026-2

0026

WORK LIGHT(S) DO NOT OPERATE (CONTINUED)

THAAD0042

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shocks to personnel.

NOTE

Troubleshooting for MRP and outrigger control station work lamps are similar.

Troubleshooting for MRP control station work lamp shown.

Step 2.

Disconnect chassis harness connector from non-operating work lamp switch connector.

Turn work lights on (WP 0005). Check for 22 to 28 vdc between wire 1040 at work lamp

switch connector, terminal A and a know good ground.

If 22 to 28 vdc are not present, repair chassis harness wire 1040

(TM 9-2320-325-14&P) or notify Supervisor.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION