TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 242 of 1616

TM 9-2320-440-13&P

0026-4

0026

WORK LIGHT(S) DO NOT OPERATE (CONTINUED)

THAAD0044

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shocks to personnel.

Step 6.

Disconnect work light from chassis harness connector (WP 0091). Turn work lights on

(WP 0005). Check for 22 to 28 vdc between chassis harness work light connector,

terminals A (wire 1040) and B (wire 1435).

If 22 to 28 vdc are present, go to Step 8.

Step 7.

Check for 22 to 28 vdc between wire 1040 at chassis harness work light connector,

terminal A to a known good ground.

a.

If 22 to 28 vdc are present, repair chassis harness wire 1435

(TM 9-2320-325-14&P) or notify Supervisor.

b.

If 22 to 28 vdc are not present, repair chassis harness wire 1040

(TM 9-2320-325-14&P) or notify Supervisor.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION