TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 179 of 772
TM 9-2350-280-20-1-2
POWERPLANT RIGHT BANK OIL COOLER FRAME AND BRACKETS REPLACEMENT (2D ENGINE) (Sheet 5 of 9)
13.
Using 9/16 inch socket with extension, or 1/2 inch
wrench, remove six brackets (N).
14.
Using 11/16 inch socket, remove two self-locking
nuts, washers, and spacer
s
from three frame
support brackets (P).
Remove frame support
brackets (P).
Throw self-locking nut away.
15.
Check oil cooler support frame (Q) for dents and breaks.
Repair if possible, or replace if necessary.
16.
Check timing access cover (R) for breaks.
Replace if necessary.
17.
Check rubber strips (S) for tears and breaks.
Replace if necessary.
18.
Check brackets (P) and (N) for cracks and breaks.
Replace if necessary.
INSTALLATION:
1.
Position each frame support bracket (A) for
mounting.
2.
Using 11/16 inch socket, install two washers,
spacers, and n
self-locking nuts (B) to secure
each bracket.
Go on to Sheet 6
TA147554
6-102
Back to Top
