TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 479 of 783

TM 9-2350-260-20-1-3

SHIFTING CONTROL BRACKET AND CONNECTING LINK ASSEMBLY REPAIR (Sheet 5 of 9)

5.

Using two 9/16 inch wrenches, remove rod ends (H)

and (J) from stud (G) if necessary.

6.

Using two 9/16 inch wrenches, install new rod ends

(H) and (J) on stud (G) as required.

7.

Using 6 inch rule, adjust length of rod assembly to 5-

3/4 inches center-to-center of rod end holes.

8.

Using two 9/16 inch wrenches, tighten jamnuts (K)

while maintaining 5-3/4 in measurement.

9.

Using 3/4 inch wrench, remove nut (L).

10. Remove link assembly (M).

11. Inspect bearing (N) and link (M).

Replace if

required.

NOTE

If bearing (N) is to be replaced,

perform steps 12 and 13.

If not,

proceed to step 14.

12. Using 3/4 inch punch and hammer, remove bearing

(N) from bracket (P).

13. Using vise, press new bearing (N) in bracket (P).

Go on to Sheet 6

TA146602

11-48