TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 483 of 783

TM 9-2350-260-20-1-3

SHIFTING CONTROL BRACKET AND CONNECTING LINK ASSEMBLY REPAIR

(Sheet 9 of 9)

7.

Install shield (H) over shield (B) with holes alined.

8.

Position seal assembly (J) over shield (H) with holes

alined.

9.

Position two flat washers (K) on seal assembly with

holes alined.

10. Using 7/16 inch socket, install five lockwashers (L) and

screws (M) and secure seal assembly (J) and shield (H)

to shield (B).

11. Position new gasket (N) and spacer (P) on shield (B)

with holes alined.

12. Using 7/16 inch socket, install four lockwashers (Q)

and screws (R) through spacer (P) and gasket (N).

13. Lubricate connecting link at grease fitting (S) using

grease (Item 37, Appendix D).

14. Position clamp (T) on cable (U).

15. Position cable (U) and clamp (T) on hull wall.

16. Using 7/16 inch wrench, install screw (V) through

clamp (T).

17. Insert shaft assembly (W) into link assembly.

18. Install 2A powerplant (page 5-14) or 2D powerplant

(page 5-40).

19. Check

shifting

pattern

response

(TM 9-2350-260-10).

If transmission does not shift

correctly, adjust shifting linkage (page 11-2).

End of Task

TA146606

11-52