TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 511 of 783

TM 9-2350-260-20-1-3

FINAL DRIVE (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 4)

9.

Using socket, cheater bar, and offset link as

required, remove 17 self-locking nut (D) holding final

drive (B) to hull.

Throw self-locking nuts (D) away.

WARNING

Keep hands clear of areas where final

drive could swing and crush them.

Do not stand where final drive could

fall on feet or legs.

10. Keeping hoist chain tight, slowly pull final drive (B)

from hull.

11. Using hoist, slowly lower final drive (B) to a solid

surface.

INSTALLATION:

1.

Using hoist, attach hook to lifting eye (A) on final drive (B).

Take slack out of hoist chain.

2.

Using brush (Item 10, Appendix D) and sealing

compound (Item 27, Appendix D), coat final drive

mating surface on hull (C).

WARNING

Keep hands and feet from under final

drive and from between hull and final

drive to prevent injury in case final

drive slips.

3.

Using hoist, lift final drive (B) and position it so that

studs are in alignment with mating surface on hull

(C).

Go on to Sheet 4

TA146635

12-4