TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 514 of 783

TM 9-2350-260-20-1-3

FINAL DRIVE STUD REPLACEMENT (Sheet 2 of 2)

INSTALLATION:

1.

Using clean brush (Item 10, Appendix D), lightly coat

tapped stud holes (A) with primer (Item 49, Appendix

(D).

2.

Using dean brush, lightly coat threads of studs (B)

with sealing compound (Item 26, Appendix D).

3.

Thread two hex nuts on new stud and using both 1-

1/2 inch wrenches, jam the nuts.

Using 1-1/2 inch

wrench on top nut, install new stud.

NOTE

Any stud installed in area (C) must

protrude 2-15/16 inches out of tapped

stud hole.

Any stud installed in area

(D) must protrude 2-1/4 inches out of

tapped stud hole.

4.

Install final drive (page 12-4).

End of Task

TA146638

12-7