TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 517 of 783

TM 9-2350-260-20-1-3

FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT (Sheet 2 of 2)

INSTALLATION:

1.

Position new seal (A) in tank.

2.

Make sure rubber lip of seal (A) is toward inside of

tank hull.

3.

Using hammer (B) and block of wood (C), tap seal

(A) into place.

NOTE

Seal is seated when tapped in as far

as it will go

4.

Make sure all sand, grit, and accumulated debris

has been removed from the final drive adapter

assembly (D).

5.

Apply grease (Item 38, Appendix D) inside final drive

adapter assembly (D) and on final drive assembly

spline (E).

6.

Using oil (Item 44, Appendix D), lightly coat outside

surface of final drive adapter assembly (D).

7.

Aligning internal splines in final drive adapter

assembly (D) with splines on input shaft, slide final

drive adapter assembly (D) onto input shaft and into

seal (A).

8.

Install 2A powerplant (page 5-14) or 2D powerplant

(page 5-40).

End of Task

TA146641

12-10