TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 525 of 783

TM 9-2350-260-20-1-3

UNIVERSAL JOINT REPLACEMENT (Sheet 6 of 7)

NOTE

It may be necessary to use prybar to

wedge universal joint to prevent it

from turning while tightening screws

(E).

11. Using 13/16 inch socket, tighten four screws (E).

12. Using 13/16 inch socket and torque wrench, tighten

four screws (E) to 110-130 lb-ft (146-173 N

•

m).

13. Using slip joint pliers, install lockwire (G) (Item 60,

Appendix D) to each two adjacent screws (E).

NOTE

Two persons are needed to perform

steps 14 and 15.

After splines are

lined up (in step 14), person using

crowbar (H) will have to move handle

of crowbar (H) repeatedly, left and

right, to strike flange (A) to have final

drive flange (A) engage final drive

adapter (J).

14. Position universal joint (B) so final drive flange (A)

splines match up with final drive adapter assembly

(J) splines.

Manually turn universal joint (B) left or

right to match up splines.

15. Using rope (K) and crowbar (H), slide final drive

adapter assembly (J) away from final drive to

engage final drive flange (A).

Go on to Sheet 7

TA146647

12-16