TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 521 of 783

TM 9-2350-260-20-1-3

UNIVERSAL JOINT REPLACEMENT (Sheet 4 of 7)

18. Using hammer, tap final drive flange (Q) loose from

universal joint (L).

19. Remove final drive flange (Q) from universal joint

(L).

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable.

To prevent personal injury,

wear protective goggles and gloves and use only in a well-ventilated area.

Avoid

contact with skin, eyes, and clothes and don't breathe vapors.

Do not use near

open flame or excessive heat.

The flash point for Type #1 Dry Cleaning Solvent is

100 F (38 C) and for Type #2 is 138 ° F (50 C).

If you become dizzy while using

cleaning solvent, get fresh air immediately and get medical aid.

If contact with

eyes is made, wash your eyes with water and get medical aid immediately.

20. Wearing rubber gloves (Item 74, Appendix D) and

using rags (Item 65, Appendix D) and dry cleaning

solvent (Item 54, Appendix D), clean final drive

flange (Q).

21. Check final drive flange (Q) for cracks and breaks.

Replace if necessary.

INSPECTION:

1.

Using brush (Item 70, Appendix D) and solvent (Item 54, Appendix D) clean quick-disconnect clamp (A).

Be sure

tapped hole (B) is free of grease and dirt.

2.

Inspect tapped hole (B) for cross-threaded or stripped threads.

If threads are damaged, replace quick-disconnect

clamp (A).

3.

Check for looseness of pin (C).

If pin (C) is loose, replace quick-disconnect clamp (A).

Go on to Sheet 4.1

12-14

Change 2