TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 533 of 783

TM 9-2350-260-20-1-3

BRAKES ADJUSTMENT (Sheet 4 of 8)

CAUTION

Make sure brakes are fully released before making brake adjustment.

Failure to

fully release brakes can cause internal damage to cross-drive transmission.

8.

If index line (B) marked R, and index mark (C) are

lined up, using 7/16 inch wrench, hold brake

adjusting worm (F).

Using 15/16 inch wrench,

tighten locknut (E).

6.

Using 7/16 inch wrench, turn brake adjusting worm

(F) about 25 turns in opposite direction of arrow (G).

7.

Using 7/16 inch wrench, attempt to line up index line

(B) marked R with index mark (C) by turning brake

adjustment worm (F) in direction of arrow (G).

NOTE

If index line (B) marked R, and index mark (C) are not lined up, notify supervisor

that brakes require higher level maintenance.

Go on to Sheet 5

TA146293

13-5