TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 540 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 3 of 17)

12. Try to insert alinement pin through alinement hole (G) in bracket (H) and lever (J).

If alinement pin cannot be inserted,

go to step 13.

If alinement pin can be inserted, go to step 40.

13. Using 3/4 inch socket, remove screw

and

lockwasher (K).

Throw lockwasher away.

14. Manually move lever (J) and insert alinement pin into

alinement hole (G).

15. Using 3/4 inch wrench, loosen jamnuts (L) and (M).

16. Using 3/4 inch wrench, adjust rod end bearing (N) by turning clockwise or counterclockwise until screw (K) will slip

freely through lever (J) and rod end bearing (N).

17. Check if brake pedal levers (P) and (Q) are touching.

If levers are touching, go to step 18.

If levers are not touching,

go to step 22.

18. Using 1/16 inch diameter wire, check to see if rod (R) is past holes (S) and (T).

If rod (R) is past holes (S) and (T), go

to step 19.

If rod (R) is not past hole (S), do steps 24 through 30.

If rod (R) is not past hole (T), go on to step 32.

19. Install screw and new lockwasher (K).

Using 3/4 inch socket, tighten screw (K).

20. Using 3/4 inch wrench, tighten jamnuts (L) and (M).

21. Remove alinement pin from alinement hole (G).

Go on to Sheet 4

TA146300

13-12