TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 543 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 6 of 17)

37. Using 3/4 inch socket, install new lockwasher, and

screw (K) through lever (J) and rod end bearing (N).

38. Using 3/4 inch wrench, tighten jamnuts (L) and (M)

up against rod end bearings (N) and (V).

39. Remove alinement pin from alinement hole (G).

Go

on to step 40.

40. Lift pawls (W) and rotate ratchet (X) until it is

approximately centered on stud (Y).

41. Check that lever assembly (Z) in guide assembly

(AA) is completely back.

If lever assembly is

completely back, go on to step 55.

If lever assembly

is not completely back, perform steps 42 through 54.

Go on to Sheet 7

TA146303

13-15