TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 547 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 10 of 17)

59. Using 3/4 inch wrench, loosen jamnut (AR).

60. Using 3/4 inch socket, remove screw and

lockwasher (AS).

Throw lockwasher away.

61. Remove rod end bearing (AT) from link (AU).

62. Insert alinement pin into alinement hole (AP) in link

(AU) and into casting boss.

63. Using 3/4 inch wrench, adjust rod end bearing (AT)

until screw (AS) can be slipped freely through link

(AU) and rod end bearing (AT) and equalizer plate

(AQ) centerline is parallel with centerline of tank.

64. Using 1/16 inch diameter wire, check to see if rod (AV) is past hole (AW).

If rod (AV) is past hole (AW), go to step 76.

If rod (AV) is not past hole (AW), do steps 65 through 75.

Go on to Sheet 11

TA146307

13-19