TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 550 of 783
TM 9-2350-260-20-1-3
BRAKE LINKAGE ADJUSTMENT (Sheet 13 of 17)
86. Using 3/4 inch socket, install new lockwasher and screw (B) through link (AU) and rod end bearing (BK).
87. Using 3/4 inch wrench, tighten jamnuts (BB) and (BH) up against rod end bearings (BC) and (BK).
88. Remove alinement pin from alinement hole (AK).
Go on to step 96.
89. Using 3/4 inch socket, remove screw and lockwasher (BJ) and remove rod end bearing (BK) from link (AU).
Throw
lockwasher away.
90. Using 9/16 inch wrench, adjust rod end bearing (BK) clockwise until rod (BE) is past hole (BG).
91. Using 3/4 inch socket, remove screw and lockwasher (AM) and remove rod end bearing (BC) from lever (BD).
Throw
lockwasher away.
92. Using 3/4 inch socket, install new lockwasher and screw (BJ) through rod end bearing (BK) and link (AU).
93. Using 3/4 inch wrench, adjust rod end bearing (BC) by turning clockwise or counterclockwise until screw (AM) will
drop freely through rod end bearing (BC) and lever (BD).
94. Using 3/4 inch socket install new lockwasher and screw (AM) through lever (BD) and rod end bearing (BC).
Go on to Sheet 14
TA146310
13-22
Back to Top
