TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 549 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 12 of 17)

76. Insert alinement pin into alinement hole (AK).

77. Using 3/4 inch wrench, loosen jamnut (BB).

78. Using 3/4 inch wrench, adjust rod end bearing (BC) until screw (AM) can be slipped freely through lever (BD) and rod

end bearing (BC).

79. Using 1/16 inch diameter wire, check to see if rod (BE) is past holes (BF) and (BG).

If rod (BE) is past holes (BF) and

(BG), go to step 96.

If rod (BE) is not past hole (BF), do steps 80 through 88.

If rod (BE) is not past hole (BG), go on

to step 89.

80. Using 3/4 inch wrench, loosen jamnut (BH).

81. Using 3/4 inch socket, remove screw and lockwasher (AM) and remove rod end bearing (BC) from lever (BD).

82. Using 3/4 inch wrench, adjust rod end bearing (BC) clockwise until rod (BE) is past hole (BF).

83. Using 3/4 inch socket, remove screw and lockwasher (BJ) and remove rod end bearing (BK) from link (AU).

Throw

lockwasher away.

84. Using 3/4 inch socket, install new lockwasher and screw (AM) through rod end bearing (BC) and lever (BD).

85. Using 3/4 inch wrench, adjust rod end bearing (BK) by turning clockwise or counterclockwise until screw (BJ) will drop

freely through rod end bearing (BK) and link (AU).

Go on to Sheet 13

TA146309

13-21