TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 548 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 11 of 17)

65. Using 3/4 inch wrench, loosen jamnut (AX).

66. Remove screw (AS) and remove rod end bearing

(AT) from link (AU).

67. Using 9/16 inch wrench, adjust rod end (AT)

clockwise until rod (AV) is past alinement hole (AW).

68. Using diagonal pliers, remove cotter pin (AY) and

remove pin (AZ).

Throw cotter pin away.

69. Remove clevis (BA) from equalizer plate (AQ).

70. Using 3/4 inch socket, install screw and new lockwasher (AS) through link (AU) and rod end bearing (AT).

71. Position equalizer plate (AQ) centerline to be parallel with centerline of tank.

72. Adjust clevis (BA) counterclockwise until pin (AZ) can be slipped freely through clevis (BA) and equalizer plate (AQ).

73. Install pin (AZ) through clevis (BA) and equalizer plate (AQ).

74. Using long nose pliers, install new cotter pin (AY) through pin (AZ).

75. Using 3/4 inch wrench, tighten jamnuts (AX) and (AR) against shanks of clevis (BA) and rod end bearing (AT).

Go on

to step 76.

Go on to Sheet 12

TA146308

13-20