TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 542 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 5 of 17)

29. Using 3/4 inch socket, install new lockwasher and

screw (U) through lever (P) and rod end bearing (V).

30. Using 3/4 inch wrench, tighten jamnuts (L) and (M)

up against rod end bearings (N) and (V).

31. Remove alinement pin from alinement hole (G).

Go

on to step 40.

32. Using 3/4 inch socket, remove screw and

lockwasher (U) and remove rod end bearing (V) from

lever (P).

Throw lockwasher away.

33. Using 3/4 inch wrench, adjust rod end bearing (V)

clockwise until rod (R) is past hole (T).

34. Using 3/4 inch socket, remove screw and

lockwasher (K) and remove rod end bearing (N) from

lever (J).

Throw lockwasher away.

35. Using 3/4 inch socket, install new lockwasher and screw (U) through rod end bearing (V) and lever (P).

36. Using 3/4 inch wrench, adjust rod end bearing (N) by turning clockwise or counterclockwise until screw (K) will drop

freely through rod end bearing (N) and lever (J).

Go on to Sheet 6

TA146302

13-14