TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 551 of 783

TM 9-2350-260-20-1-3

BRAKE LINKAGE ADJUSTMENT (Sheet 14 of 17)

95. Using 3/4 inch wrench, tighten jamnut (BB) and (BH) up against rod end bearings (BC) and (BK).

Go on to step 96.

96. Using 3/4 inch wrench, loosen jamnut (BL).

97. Insert alinement pin into alinement hole (AL).

98. Using 3/4 inch wrench, adjust rod end bearing (BM)

until screw (AN) can be slipped freely through lever

(BN) and rod end bearing (BM).

99. Using 1/16 inch diameter wire, check to see if rod (BP) is past hole (BQ).

If rod (BP) is past hole (BQ), do step 104.

If

rod (BP) is not past hole (BQ), do steps 100 through 108.

Go on to Sheet 15

TA146311

13-23