TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 577 of 1008

TM 9-2350-261-20-2

REPLACE TRAILER HARNESS

0328 00

THIS WORK PACKAGE COVERS:

Removal (page 0328 00-1).

Inspection-Acceptance and Rejection Criteria (page 0328 00-2).

Installation (page 0328 00-2).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

Digital Multimeter (WP 0780 00, Item 43)

General Mechanic’s Tool Kit (WP 0780 00, Item 29)

Materials/Parts

Gasket

Lockwasher (2)

Personnel Required

Unit Mechanic

Equipment Condition

Engine stopped/shutdown (see your -10)

Carrier blocked (see your -10)

Ramp raised (see your -10)

Rear floor plates removed (WP 0436 00)

Battery ground lead disconnected (WP 0294 00)

REMOVAL

1.

Disconnect rear wiring harness circuit 21, 22, 23, and 24 leads (1) from trailer wiring harness circuit 21, 22, 23, and

24 leads (2).

2.

Remove shell connectors from leads (2) (WP 0314 00).

3.

Remove screw (3), clamp (4), two lockwashers (5), and circuit 90 lead (6) from hull weldnut. Discard lockwashers.

4.

Remove four screws (7) and receptacle cover (8) from ramp. Carefully remove receptacle (9) with attached leads (2)

and gasket (10) from ramp. Discard gasket.

5.

If needed, remove connector (11) from rear bulkhead.

6.

If needed, remove spring (12) and elbow (13) from ramp.

032800-1