TM-9-2350-311-20-1

HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A2, M109A3, M109A4 AND M109A5

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL FOR HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS

AUGUST 1994

TM-9-2350-311-20-1 - Page 897 of 1275

TM9-2350-311-20-1

9-11 ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR —

CONTINUED

a. Removal — Continued

13

14

15

16

17

Remove pin (30) and lever (31).

NOTE

Remove inserts (32 and 33) only if threads are damaged and inserts must be

replaced.

Remove three screws (34), three lockwashers (35), and three inserts (32) at bracket support assembly (36).

Discard Iockwashers.

Remove bracket support assembly (36) from bulkhead.

Remove cotter pin (37) and pin (38) at end of throttle control rod (39) for removal of linkage in driver's

compartment. Discard cotter pin.

NOTE

Throttle control rod (39) is part of hand throttle control assembly (40).

Remove screw (41), key washer (42), and throttle control assembly (40). Remove insert (33) if necessary.

Discard key washer.

9-42