TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 715 of 933

TM 9-2520-270-34

22. REMOVE AND DISCARD PREFORMED

PACKING (1).

23. REMOVE SPUR GEAR (2) AND

COUPLING (3).

24. INSPECT MAIN HOUSING INSERTS.

a. Repair inserts if damaged. See task

REPAIR MAIN HOUSING INSERTS,

page 4-150.

25. INSPECT SPUR GEAR (2).

a. Inspect gear (2) for damage. See

page 2-5. If gear is not damaged, go

to step 26. If gear is damaged, go to

step 28.

26. CHECK GEAR (2).

I

a. Using telescoping gage set and

I

27. INSPECT TWO BEARINGS (4).

micrometer caliper set, measure inside

diameter of gear (2). If measurement

is 4.9204 inches (124.99 mm) or less,

go to step 27. If not, go to step 28.

a. Inspect two bearings (4) for damage.

See TM 9-214. If either bearing is

damaged, go to step 28. If not, go to

step 31.

4-382