TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 720 of 933
CAUTION
Do not twist hose assembly when connecting
to elbow. Damage to equipment can occur.
49. CONNECT HOSE ASSEMBLY (1).
a. Connect and hand tighten hose
assembly (1) to elbow (2).
50. USING OPEN-END WRENCH, HOLD HOSE
NUT (3).
51. USING 3/8-lNCH DRIVE TORQUE
WRENCH AND 9/16-INCH CROWFOOT
TORQUE SWIVEL NUT (4) TO
125-135 in-lb (144-155 cmkg).
51.1 RETORQUE LOCKNUT (5) ON
ELBOW (2).
a. Loosen locknut (5) on elbow (2) to
zero torque.
b. Hold elbow (2) from turning.
c. Torque locknut (5) to 125-135 in-lb
(144-155 cmkg).
TM 9-2520-270-34
CAUTION
Do not twist hose assembly when connecting
to elbow. Damage to equipment can occur.
52. CONNECT HOSE ASSEMBLY (6).
a. Connect and hand tighten hose
assembly (6) to elbows (7) and (8).
53. USING OPEN-END WRENCH, HOLD HOSE
NUT (9).
54. USING 3/8-lNCH DRIVE TORQUE
WRENCH AND 9/1 6-INCH CROWFOOT
TORQUE SWIVEL NUT (10) TO
125-135 in-lb (144-155 cmkg).
54.1 RETORQUE LOCKNUTS (11) ON
ELBOWS (7) and (8).
a.
b.
c.
Loosen locknuts (11) on elbows (7)
and (8) to zero torque.
Hold elbows (7) and (8) from turning.
Torque locknuts (11) to 125-135 in-lb
(144-155 cmkg).
GO TO NEXT PAGE
Change 3
4-387
Back to Top
