TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 717 of 933

TM 9-2520-270-34

33. ATTACH REMOVAL ASSEMBLY (1).

a. Install two screws (2) in screw

holes (3) in hydraulic assembly (4).

b. Tighten two screws (2).

WARNING

Hanging loads could kill

or injure you. Keep away

from hanging loads and

overhead equipment.

34. LIFT HYDRAULIC ASSEMBLY (4) OFF

WORK SURFACE.

a. Attach lifting device (5) to

removal assembly (1).

b. Lift hydraulic assembly (4) off work

surface.

35. IF REMOVED, INSTALL LEFT-HAND

HYDRAULIC ASSEMBLY. See task

REPLACE LEFT-HAND HYDRAULIC

ASSEMBLY, page 4-360.

CAUTION

Do not contact hoses with hydraulic assembly

when lowering into transmission. Damage to

equipment can occur.

NOTE

Transmission must be level with right side

up on tip-over stand.

36. REPAIRER AND HELPER POSITION

HYDRAULIC ASSEMBLY (4).

a. Lower hydraulic assembly (4) into

right side of transmission housing (6)

until it rests on top of spur gear (7).

4-384