TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 721 of 933

TM 9-2520-270-34

55. INSTALL CLUTCH HOUSING (1).

a. Working on right side of transmission

housing (2), hold clutch housing (1)

on gearshaft spline (3) and aline six

screw holes.

b. Install six screws (4).

56. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX SCREWS (4).

a. (H) Use pry bar to hold clutch

housing (1) from turning.

b. Torque six screws (4) to 10-12 ft-lb

(1-2 mkg).

62.

58. INSTALL CROSS SHAFT ASSEMBLY.

See task REPLACE CROSS SHAFT

ASSEMBLY, page 4-458.

59. DELETED.

60. INSTALL POSITIVE CLUTCH. See

task REPLACE POSITIVE CLUTCH,

page 4-356.

57. INSTALL SPUR GEAR (5) WITH

SHAFT (6) AND THRUST

WASHER BEARING (7).

61. INSTALL LEFT-HAND INTERMEDIATE

HOUSING ASSEMBLY. See task

REPLACE LEFT-HAND INTERMEDIATE

HOUSING ASSEMBLY, page 4-220.

a.

b.

Working on left side of transmission

housing (2), install thrust washer

bearing (7). Two tabs on bearing go

into two holes (8) in left-hand

hydraulic assembly (9).

Install spur gear (5) with splined

straight shafi (6). Spur gear goes

all the way into differential carrier

assembly (10).

63.

64.

INSTALL RIGHT-HAND INTERMEDIATE

HOUSING ASSEMBLY. See task

REPLACE RIGHT-HAND INTERMEDIATE

HOUSING ASSEMBLY, page 4-170.

INSTALL RIGHT-HAND OUTPUT

HOUSING. See task REPLACE RIGHT-

HAND OUTPUT HOUSING, page 4-270.

INSTALL LEFT-HAND OUTPUT

HOUSING. See task REPLACE

LEFT-HAND OUTPUT HOUSING,

page 4-314.

INSTALL CONTROLLER ASSEMBLY.

65.

See task REPLACE CONTROLLER

ASSEMBLY, page 3-32.

END OF TASK

4-388

Change 3