TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 188 of 620
TM 9-2520-272-40
0024
17.Remove the needle bearing (Figure 6, Item 9) from the right brake support assembly (Figure 6, Item 6).
18.Turn the right brake support assembly (Figure 7, Item 6) over so that the external side points up, and put the
right brake support assembly on a wooden block (Figure 7, Item 1) support placed near the pipe plug (Figure
7, Item 10).
19.Remove the pipe plug (Figure 7, Item 10) from the right brake support assembly (Figure 7, Item 6).
20.Check the bearing bores in the support for damage. Use crocus cloth to make scratches smooth. If there is
grinding damage, replace the support.
NOTE
Some pipe plugs are precoated and do not require thread-locking compound lubricating sealant.
21.Apply lubricating sealant to the threads of the pipe plug (Figure 7, Item 10), if necessary.
22.Install the pipe plug (Figure 7, Item 10) in the right brake support assembly (Figure 7, Item 6). Torque the
pipe plug (Figure 7, Item 10) to 5 lb-ft (6 to 7 N·m).
Back to Top
