TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 571 of 856

REPAIR OR REPLACEMENT - Continued

WARNING

Dry cleaning solvent MIL-PRF-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. Do not use near open flame or excessive heat. The

flash point is 100–138

°

F (38–59

°

C). If you become dizzy while using cleaning solvent,

get fresh air immediately and seek medical aid. If contact with eyes is made, wash

with water and get medical aid immediately. Failure to comply may result in injury,

illness, or death to personnel.

NOTE

When using MIL-PRF-680 solvents, ensure MIL-PRF-680 solvent container is sealed.

Store, handle and dispose unused and spent solvents in accordance with local

procedures and plans.

f.

When part is flat, wash in cleaning solvent and dry with compressed air.

g.

Place part on second block (Figure 9, Item 33). Apply 600 grit lapping compound to block and repeat

Steps 1.c.–1.f.

h.

Place part on third block (Figure 9, Item 33). Do not apply lapping compound to this block and repeat

Steps 1.c.–1.f.

33

16

19

13

5

MAINT_283

Figure 9.

Parts Placement on Lapping Block.

END OF TASK

TM 9-2815-205-24

0084

0084-11