TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 617 of 856
ASSEMBLY - Continued
2.
Governor spring pack procedures:
a.
Thread screw (Figure 7, Item 30) into plunger (Figure 7, Item 21).
NOTE
Install original shims and special washers if available. If original shims and special
washers are not available, install five shims and five special washers.
b.
Install shims (Figure 7, Item 27), special washers (Figure 7, Item 26), and spring (Figure 7, Item 28) on
plunger (Figure 7, Item 21) with thin special washers first.
c.
Lubricate spring (Figure 7, Item 28) and plunger (Figure 7, Item 21) with engine oil.
d.
Place packing nut (Figure 7, Item 31) over plunger (Figure 7, Item 21) and thread nut
(Figure 7, Item 29) on screw (Figure 7, Item 30) until 1/4 inch (6.35 mm) of screw extends beyond nut.
e.
Lubricate pin (Figure 7, Item 22), spring seat (Figure 7, Item 23), spring (Figure 7, Item 25), and
retainer (Figure 7, Item 24) with engine oil and install into end of plunger (Figure 7, Item 21) as shown.
26
25
24
27
28
29
23
22
30
21
31
MAINT_316
Figure 7.
Governor Spring Pack Installation.
TM 9-2815-205-24
0087
0087-9
Back to Top
