TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 613 of 856
DISASSEMBLY - Continued
j.
Remove operating shaft (Figure 4, Item 53), bearing (Figure 4, Item 44), operating shaft lever
assembly (Figure 4, Item 61), and shifter fork (Figure 4, Item 65) from governor housing
(Figure 4, Item 43).
k.
Press operating shaft (Figure 4, Item 54) from operating shaft lever assembly (Figure 4, Item 61) and
bearing (Figure 4, Item 44).
l.
If necessary, press pin (Figure 4, Item 40) from operating shaft lever (Figure 4, Item 55).
m.
On model 5063-5299, remove nut (Figure 4, Item 56) and screw (Figure 4, Item 57) from operating
shaft lever (Figure 4, Item 55).
n.
On all except model 5063-5299, remove bolt (Figure 4, Item 58), special nut (Figure 4, Item 60), and
nut (Figure 4, Item 59) from operating shaft lever (Figure 4, Item 55).
o.
Press ball bearing (Figure 4, Item 53) from governor housing (Figure 4, Item 43).
p.
If necessary, remove plug (Figure 4, Item 64) from side of governor housing (Figure 4, Item 43).
Discard plug.
q.
If necessary, remove two pins (Figure 4, Item 69) from top of governor housing (Figure 4, Item 43).
r.
If necessary, remove two adapters (Figure 4, Item 68) from sides of governor housing
(Figure 4, Item 43).
s.
If necessary, remove two pins (Figure 4, Item 67) from front and pin (Figure 4, Item 66) from rear of
governor housing (Figure 4, Item 43).
t.
If necessary, remove two drive screws (Figure 4, Item 62) and plate (Figure 4, Item 63) from side of
governor housing (Figure 4, Item 43).
u.
If necessary, remove pin (Figure 4, Item 46) from inside governor housing (Figure 4, Item 43).
63
64
65
66
53
67
68
62
69
70
58
57
56
55
54
53
52
61
60
59
43
40
46
44
43
65
54
MODEL
5063-5299
MODELS
5063-5392
5063-5393
5063-539L
MAINT_313
Figure 4.
Governor Housing Assembly.
END OF TASK
TM 9-2815-205-24
0087
0087-5
Back to Top
